Main Access Power Ionizer Hybrid Complete Swimming Pool Care Sanitation System

Description

The Power Ionizer provides swimming pools with a better quality of water, while eliminating the daily usage of harsh chemicals such as chlorine and bromine. The system chamber disperses natural minerals into the water, such as copper and silver, that act as natural algaecides. These natural mineral levels can be easily maintained by adjusting the dial on the side of the unit. The Power Ionizer offers such advanced technology that it is truly a low maintenance system; simply set the dial, relax and enjoy your pool!
The Power Ionizer System utilizes natural minerals, such as copper and silver, while eliminating the daily usage of harsh chemicals such as chlorine or bromine. By simply adjusting the dial, the natural mineral level can easily be maintained between 0.3-0.6 ppm. Traditional salt systems can cause corrosion to the steel wall on top rails. More and more, pool manufacturers will not warranty a pool that uses a traditional salt system. The Power Ionizer System utilizes a minimal amount of salt in a unique way; simply to kick-start the process and then allows natural minerals to take over. This process is environmentally friendly and safe for your pool. There are also a few simple chemicals that help keep your pool sparkling clear!
Utilizes natural minerals for swimming pool care
Allows you to spend less time and less money
Proven technology utilizes copper and silver to sanitize pool
Reduces itchy skin, eye irritation, faded suits, and chemical odors
Easy to install and easy to use
Features
Utilizes natural minerals for swimming pool care
Allows you to spend less time and less money
Proven technology utilizes copper and silver to sanitize pool
Reduces itchy skin, eye irritation, faded suits, and chemical odors
Easy to install and easy to use
Treats up to 40,000 gallons of water
PH Neutral
Greatly reduces time spent balancing chemicals
Non-traditional, hybrid salt system
Non-corrosive
One-time application of salt
Pet friendly
Start Up For The Power Ionizer System
Install on the return side of the filter in any direction. Without a flow switch, the system utilizes unique water flow vibration technology.
Turn system control knob to 3 to start, making sure that the green "Active" light is on when the pump is running.
During initial fill, add salt (typically 40-80lbs.) to achieve a 1,000 ppm reading of Total Dissolved Solids.
Add entire bucket of Condition by broadcasting into pool.
Use the test strips provided to balance pH, alkalinity, and copper.
Water Testing For The Power Ionizer
Alkalinity between 80-150 ppm.
pH between 7.2-7.6 ppm.
Calcium Hardness between 180-250 ppm.
Test mineral level (copper) between .3-.6 ppm. TDS must be over 1,000 ppm *may take up to 3 days for initial level to get within ideal range
Iron and other metals should be zero.
Maintenance For The Power Ionizer
Weekly water test to balance all levels, including natural minerals (copper).
Use the control knob to adjust copper to within ideal range of 0.3-0.6 ppm.
Note: If the control knob is turned to maximum it may shut down the unit, leaving the red "chamber" light on. Simply turn the control knob down until the red light goes off and the green light remains on.
The green "Active" light will be lit when the pump is on. This will give the most accurate temperature reading as well as indicate the Power Ionizer is functioning properly.
Shock every other week with one bag of Refresh per 10,000 gallons of water.
Pour one pint of Cleanse (natural enzyme clarifier) per 10,000 gallons of water, directly into pool every other week.
To winterize, remove the Power Ionizer unit and store it in a cool, dry place.
The chamber needs to be replaced approximately once a season.
Replacement time indicated by the red "chamber" light.
Installs in Minutes!
Works on In-Ground and Above-Ground pools (3,500
40,000 gallons).
Compatible with all filtration systems.
Eliminates chlorine usage on a daily basis